Nova versão de firmware para o rádio DX8 já está disponível no site da comunidade Spektrum https://community.spektrumrc.com/Login.aspx. Para realizar o download do arquivo da nova versão para o seu DX8 é necessário realizar o registro no site. O arquivo de atualização é exclusivo, sendo criado com base no registro realizado.
Software Features
- Added support for GPS and High Current telemetry sensors.
- Enabled up to 32-pole motors for the brushless RPM sensor.
- Enabled SD telemetry log file
- Enabled ability to configure inactivity timer
- Enabled backlight configurability (Auto/On/Off)
- Enabled dimming control of the orange Spektrum LED for night flying
- Adjusted vibe motor RPM to be less aggressive
- Added support for GPS and High Current telemetry sensors.
- Enabled up to 32-pole motors for the brushless RPM sensor.
- Enabled SD telemetry log file
- Enabled ability to configure inactivity timer
- Enabled backlight configurability (Auto/On/Off)
- Enabled dimming control of the orange Spektrum LED for night flying
- Adjusted vibe motor RPM to be less aggressive
Software Corrections
- Fixed bug that could reset the radio when scrolling through Mix options.
- Corrected L/R trimmer ‘forgetting’ assignment after power cycle.
- Improved translations in French and Italian screens.
- Corrected export of flap configuration.
- Corrected over-travel of flaps that could result in reversed operation at extreme deployments.
- Corrected switch change on Acro throttle cut screen when going from the initial switch selection to the edit page.
- Corrected timer to work properly in Throttle Out mode when using reversed throttle channel.
- Corrected end-point adjustability when Trainer is used as an input to a channel.
- Corrected trainer normal Master mode so that it doesn’t modify controls from the slave. In previous versions it could reverse channels vs. what was expected.
NOTE: This change affects sub-trim and travel of existing models and ones you will import. You may need to adjust sub-trims and travel on all control surfaces in both airplanes and helicopters.
- Fixed bug that could reset the radio when scrolling through Mix options.
- Corrected L/R trimmer ‘forgetting’ assignment after power cycle.
- Improved translations in French and Italian screens.
- Corrected export of flap configuration.
- Corrected over-travel of flaps that could result in reversed operation at extreme deployments.
- Corrected switch change on Acro throttle cut screen when going from the initial switch selection to the edit page.
- Corrected timer to work properly in Throttle Out mode when using reversed throttle channel.
- Corrected end-point adjustability when Trainer is used as an input to a channel.
- Corrected trainer normal Master mode so that it doesn’t modify controls from the slave. In previous versions it could reverse channels vs. what was expected.
NOTE: This change affects sub-trim and travel of existing models and ones you will import. You may need to adjust sub-trims and travel on all control surfaces in both airplanes and helicopters.
Fonte: Spektrum
.
Nenhum comentário:
Postar um comentário